Re: Tsearch2 default locale on postgres 8.2

["Tarabas (Manuel Rorarius)" <tarabas(at)tarabas(dot)de>]

Hi,

right ... i had a typo in the locale, it was set to "de_DE.UTF8" but
should have been set to "de_DE.UTF-8".

After that change, the "select set_curcfg('default');" worked fine.

thanx a lot...

Best regards
Manuel

Friday, December 22, 2006, 12:35:41 PM, you wrote:

HD> I think the best way is to adjust the locale for your default config:

HD> Type:
HD> SHOW lc_ctype; (or some other lc_* variables) in psql.

HD> to find your cluster locale, then:

HD> UPDATE
HD>    public.pg_ts_cfg
HD> SET
HD>    locale = '<your_locale>'
HD> WHERE
HD>    ts_name = 'default';


HD> On 22.12.2006 11:55, Tarabas (Manuel Rorarius) wrote:
>>    I am having a tsearch2 problem on postgres 8.2 again ...
>>    when I try to set the default config for tsearch2 with
>> 
>>    "select set_curcfg('default'); it works fine in the same pgadmin
>>    session when i use "select show_curcfg();" afterwards. The correct
>>    OID is shown.
>> 
>>    If i then close the query window and open a new one and then try
>>    the "select show_curcfg();" again, it states
>>    "ERROR:  could not find tsearch config by locale"
>> 
>>    Any idea why the configuration is not saved correctly?